FPGA DEVICES · ENGINEERING · SOURCING Source-linked information. Clear project requirements.

Hard-to-find

6116LA20SOG8 — sourcing the 5 V SRAM for a legacy board

Published · Updated

Renesas identifies 6116LA20SOG8 as a 2K × 8 asynchronous SRAM supplied on reel. A maintenance buyer should separate three decisions: keeping the required 5 V bus characteristics, meeting the board’s read and write timing, and supplying the package and carrier that assembly expects.

What the board expects on its memory bus

The organization is 2,048 bytes. Capacity alone does not identify a replacement.
The organization is 2,048 bytes. Capacity alone does not identify a replacement. Original decision diagram.

The Renesas exact-part page lists an asynchronous interface, 5 V core, 20 ns access time and a 24-lead PSG24 SOIC with 1.27 mm pitch. Its listed temperature range is 0 to 70 °C. Use the 6116SA/LA data sheet to check conditions for the relevant timing path. The access-time label alone cannot establish a complete read or write bus cycle.

What PLC 250016 actually discontinued

Notice, order cutoff and delivery milestone for the exact affected row.
Notice, order cutoff and delivery milestone for the exact affected row. Original decision diagram.

Renesas PLC 250016 lists 6116LA20SOG8 on page 2. The notice was issued on 2025-05-30, with last ordering on 2025-11-30 and the last shipment milestone on 2026-05-30. The alternative column for this code says None. Obtain lot-specific evidence before committing a maintenance build. The notice gives no current stock or lead time.

Screen an offer before reserving bench time

Use three separate checks to triage a proposed memory lot.
Use three separate checks to triage a proposed memory lot. Original decision diagram.

Renesas lists 6116LA20SOG8 as reel and the similarly spelled 6116LA20SOG as non-reel. Treat an offer lacking the final 8 as a carrier discrepancy and request the actual label. Even when the assembly team can accept a different carrier, verify markings, traceability, packaging and storage first. For an electrical substitution, compare chip-select, output-enable, write-enable and high-impedance timing with the controller’s actual bus schedule. Test battery-backed retention separately if the board uses it.

PLC 250016 — manufacturer withdrawal notice · Renesas exact-part specifications · 6116SA/LA data sheet and timing diagrams · Renesas non-reel variant

Show how to compare an offer with the full order codeConcept animation showing a purchase order code compared with a proposed marking

Transcribe both complete ordering numbers, mark the first difference and ask for its manufacturer definition. Keep the identity decision separate from a board substitution approval.

For an unchanged service BOM, enter the required device quantity on the homepage and request 6116LA20SOG8 with reel identification. If the original cannot be sourced, retain the board revision, bus timing evidence and standby requirements as a separate redesign brief.

Request 6116LA20SOG8 on the homepage

Back to Hard-to-find →

Source addresses and citation trail

Full source addresses are retained below. Read each citation with its document revision, page, table and applicability conditions above.

  1. https://www.renesas.com/en/document/eln/plc-250016-end-life-eol-process-select-part-numbers?r=13431
  2. https://www.renesas.com/en/products/6116/part-details/6116la20sog8
  3. https://www.renesas.com/en/document/dst/6116sala-data-sheet
  4. https://www.renesas.com/en/products/6116/part-details/6116la20sog